User's Manual
Table Of Contents
- 1 Introduction
- 2 Networking Basics
- 3 Installing Printer
- 4 Configuring the Printer
- Network Settings
- Configuring the Printer through the Operator Control Panel
- Configuring Wireless through the Printer Web Page
- Configuring Wireless through the Driver Toolbox
- Using ZXP Toolbox Wireless Settings Load/Save Buttons
- Using RADIO CONTROL Menu
- Using SET DEFAULTS Menu
- Simple Roaming Used During Connection
- Setting Up an Ad-Hoc (Peer) Network
- Multi-homing Considerations
- 5 Monitor Wireless Performance
- Wireless Info Pages
- Signal Strength
- Noise Floor
- Data Rate
- DHCP & MAC Address Info Page
- Wireless Statistics Info Page
- Wireless Statistics Success and Failure Rates
- Main Status Display Wireless Errors
- Viewing Wireless Information through Printer Web Page
- Viewing Wireless Information through Windows Printer Driver Toolbox
- 6 Troubleshooting
- 7 Technical Specifications
- 8 Glossary
- 9 Compliance Information
27
There are two approaches that can be used to configure the printer’s wireless settings. If all the
necessary information is known (SSID, BSSID, Channel, Security, Encryption and Passphrase)
these parameters can be directly entered into the Wireless Configuration. The alternate
approach is to request that the printer scan for wireless access points and select one. This
automatically fills in most of the Wireless Configuration parameters.
Step 1:
Make any changes needed to DHCP Enable, IP Address, Subnet Mask and Gateway.
If directly entering the wireless settings, skip to Step 4.