User's Manual
Table Of Contents
- 1 Introduction
- 2 Networking Basics
- 3 Installing Printer
- 4 Configuring the Printer
- Network Settings
- Configuring the Printer through the Operator Control Panel
- Configuring Wireless through the Printer Web Page
- Configuring Wireless through the Driver Toolbox
- Using ZXP Toolbox Wireless Settings Load/Save Buttons
- Using RADIO CONTROL Menu
- Using SET DEFAULTS Menu
- Simple Roaming Used During Connection
- Setting Up an Ad-Hoc (Peer) Network
- Multi-homing Considerations
- 5 Monitor Wireless Performance
- Wireless Info Pages
- Signal Strength
- Noise Floor
- Data Rate
- DHCP & MAC Address Info Page
- Wireless Statistics Info Page
- Wireless Statistics Success and Failure Rates
- Main Status Display Wireless Errors
- Viewing Wireless Information through Printer Web Page
- Viewing Wireless Information through Windows Printer Driver Toolbox
- 6 Troubleshooting
- 7 Technical Specifications
- 8 Glossary
- 9 Compliance Information
20
character position that is selected. When the display exactly matches the WEP key of the access
point, press the EXIT soft-key.
For WPA and WPA2, you may need to select the encryption mode if more than one is available.
If this is the case, the display changes to:
Press either the CCMP or TKIP soft-key to select the encryption mode. Remember that CCMP is
the stronger encryption. For WPA and WPA2, after the security mode and encryption modes
have been selected or automatically determined (if only one mode is available, the selection
display is bypassed), the WPA Passphrase must be entered. The display changes to:
The passphrase must be entered one character at a time. Each character can be any visible
ASCII character. The character that is currently being set will slowly blink. Use the CHANGE soft
key to cycle through the ASCII character set until the desired character is shown (Remember
that the passphrase is case sensitive). If there are more characters that need to be set, then
press the NEXT soft-key to add another character and use the CHANGE soft-key to select the
correct ASCII character. When the last character has been set (and while it is still blinking) press
the EXIT soft-key to complete the passphrase entry. The EXIT key will not work until at least 8
characters have been entered. (Warning - Do not press the NEXT soft-key after the last
character has been set otherwise you will need to repeat this entire step.) Note that entering
the passphrase text incorrectly will prevent successful connection to the access point.
At this point, all the information has been collected that is necessary to connect to the access
point. Please be aware that not all of the Setup Wizard screens shown above will be seen. The
printer will bypass screens that that are unnecessary to display. For instance, if an access point
is setup with only WPA security, only TKIP security and the SSID is broadcast, only the “Enter
WPA Passphrase” setup screen will be seen. The display should now be:
SELECT ENCRYPTION
MODE. IF YOU ARE
UNSURE, PICK CCMP.
CCMP TKIP CANCEL
ENTER WPA PASSPHRASE
8 – 63 CHARACTERS:
0
CHANGE NEXT EXIT