User's Manual
Table Of Contents
- Warranty
- Service Information
- Software Support
- Introduction
- Unpacking
- Related Documents
- Features
- Setting up the VC80 Software
- Connecting to Terminal Emulation
- Wireless Network Configuration
- Bluetooth
- Programmable Keys
- Installation
- Ergonomics
- Regulatory Information
- Wireless Devices Country Approvals
- Health and Safety Recommendations
- Power Supply
- Batteries
- Radio Frequency Interference Requirements-FCC
- Radio Frequency Interference Requirements - Canada
- Marking and European Economic Area (EEA)
- Waste Electrical and Electronic Equipment (WEEE)
- China RoHS
Quick Reference Guide 9
Installation
Installing the VC80 on a Forklift
1. Attach the desired mount to the VC80. Refer to the VC80 User Guide at
www.zebra.com/support for detailed mounting options and instructions.
2. Attach the mounted VC80 to the vehicle and position in a location that does not
obstruct the operator’s view.
3. If using an external antenna, connect antenna in a vertical position to the VC80.
4. Connect peripherals to the VC80. Place the cables in the strain relief brackets
inside the dust cover and replace the dust cover (see Back View on page 6).
5. Connect the VC80 to the vehicle DC supply.
6. Press the Power button to turn the device On or Off (see Front View on page 5).
CAUTION Do not install the vehicle computer in a location that affects
vehicle safety, visibility, or ability to drive.
If mounted above head height, it is recommended to also use
a safety strap with the mount bracket.
CAUTION Tighten peripherals with thumbscrews by hand only. Do not
use tools for tightening thumbscrews.
NOTE If installing peripherals, allow enough space when selecting a
mounting location.
View Obstruction Considerations