User's Manual
Table Of Contents
- Warranty
- Service Information
- Software Support
- Introduction
- Unpacking
- Related Documents
- Features
- Setting up the VC80 Software
- Connecting to Terminal Emulation
- Wireless Network Configuration
- Bluetooth
- Programmable Keys
- Installation
- Ergonomics
- Regulatory Information
- Wireless Devices Country Approvals
- Health and Safety Recommendations
- Power Supply
- Batteries
- Radio Frequency Interference Requirements-FCC
- Radio Frequency Interference Requirements - Canada
- Marking and European Economic Area (EEA)
- Waste Electrical and Electronic Equipment (WEEE)
- China RoHS
Quick Reference Guide 7
Setting up the VC80 Software
To set up VC80 software:
1. Connect the VC80 to an external power source.
2. Press the power button to turn the VC80 On.
3. Set the date and time.
4. Edit the radio parameters.
5. Edit the Control Panel settings.
6. Edit the TekTerm or Wavelink TE terminal emulation parameters (optional).
7. Only reboot if prompted.
For detailed information, refer to the VC80 User Guide at www.zebra.com/support.
Optional Software for Configuring the VC80
Configure the VC80 before fastening it to machines or vehicles. The following
software options are available:
• VC80 Control Panel for quick setup and configuration file management.
• TekWedge to interface with serial and Bluetooth scanners.
• My-T-Soft for on screen keyboard customization and key mapping.
• Windows Management Instrumentation (WMI) for VC control panel registry
setting support. With WMI, management data may be obtained from remote
computers.
• Scanner Management System (SMS) enables the remote management of
Zebra scanners using a USB interface and provides the ability to access
scanner asset information and statistics, set parameters, and update firmware.
• U-Center to configure GPS on VC80 configurations with GPS.
For detailed information, refer to the VC80 User Guide at www.zebra.com/support.