User's Manual
Adjustment
7
D1685 Rev -Draft September 2015
4 Adjustment
No adjustment is necessary once a DartTag is activated. The user may choose to program the tag transmit
rate with a Zebra configuration tool.
5 Regulatory Information
US Regulatory Information
FCC ID: XWX-UWT1100, XWX-UWT1101, XWX-UWT1200, XWX-UWT1300, XWX-UWT1301,
XWX-UWT1320, XWX-UWT1400, XWX-UWT1420, XWX-UWT1500.
This device complies with FCC Part 15.250 (c).
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference which may cause undesired operation
Additionally,
(1) Operation on board an aircraft or satellite is prohibited.
(2) Devices operating under this section may not be employed for the operation of toys.
(3) Except for operation onboard a ship or terrestrial transportation vehicle, the use of a fixed
outdoor infrastructure is prohibited. A fixed infrastructure includes antennas mounted on outdoor
structures, e.g., antennas mounted on the outside of a building or on a telephone pole.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.