User's Manual

81
Configuration
Control Panel Parameters
5/12/08 ZM™ Series/RZ™ Series User Guide 79695L-002 Rev. A
APL-I only Print Quality Test Label
A print quality test label contains test bar codes and relevant printer
settings.
To print this label:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to select
PRINT
.
3. Press
SELECT to deselect the parameter.
APL-I only Print Pitch Test Label
To print this label:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to select
PRINT
.
3. Press
SELECT to deselect the parameter.
List Network Settings
This option prints a network configuration label (see Figure 12
on page 68), which lists the settings for any print server that is installed.
To print a network configuration label:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to select
PRINT
.
3. Press
SELECT to deselect the parameter.
ZPL, XML, EPL List All
This option prints labels that list the available fonts, bar codes, images,
formats, and the current printer and network configurations.
To print labels for all settings:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to select
PRINT
.
3. Press
SELECT to deselect the parameter.
APL-I only
Print Stored APL-I Page
Up to 20 pages can be stored and printed.
Selections: 0 through 19
Default Value: 0
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.
Table 12 • Printer Parameters (Page 12 of 26)
Parameter
Action/Explanation
Configuration
Control Panel Parameters
82
79695L-002 Rev. A ZM™ Series/RZ™ Series User Guide 5/12/08
APL-I only
Print Stored APL-I Format
Up to 100 formats can be stored and printed.
Selections: 0 through 99
Default Value: 0
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.
ZPL and XML only Format Memory Card
This option erases all previously stored information from the optional
64 MB flash chip on the Wireless Plus option board. This parameter
appears only when a Wireless Plus option board with the flash chip
populated is installed.
Caution • This option completely erases the flash chip.
To format a memory card:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to select
A:
.
If your printer is set to require a password, you are prompted to enter
the password.
3. Enter the password. For instructions, see Change Password-Protected
Parameters on page 66.
4. Press the appropriate button again to select the desired card.
The display shows
ARE YOU SURE?
.
5. Do you want to continue?
• Press
MINUS (-) to select
NO
to cancel the request and return to
FORMAT CARD
prompt.
• Press
PLUS (+) to select
YES
and begin initialization.
When initialization is complete, the control panel displays
FORMATTING CARD COMPLETED
.
Note • Depending on the amount of memory in the memory card,
initialization may take up to 5 minutes to complete.
6. Press
SELECT to deselect the parameter.
Table 12 • Printer Parameters (Page 13 of 26)
Parameter
Action/Explanation