User's Manual

79
Configuration
Control Panel Parameters
5/12/08 ZM™ Series/RZ™ Series User Guide 79695L-002 Rev. A
Print Counter Readings
Prints a label that lists the odometer readings for the following:
• the non-resettable counter
• the two user-controlled counters
• the Early Warning for Maintenance counters, which indicate when the
printhead was last cleaned and the printhead life
If the Early Warning for Maintenance feature is disabled, the counters
related to it do not print.
To print a list of the odometer readings:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to print the odometer readings.
3. Press
SELECT to deselect the parameter.
List Fonts
This option prints a label that lists the available fonts in the printer,
including standard printer fonts plus any optional fonts. Fonts may be
stored in RAM or Flash memory.
To print a list of the available fonts:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to select
PRINT
.
3. Press
SELECT to deselect the parameter.
ZPL and XML only List Bar Codes
This option prints a label that lists the available bar codes in the printer. Bar
codes may be stored in RAM or Flash memory.
To print a list of the available bar codes:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to select
PRINT
.
3. Press
SELECT to deselect the parameter.
List Images
This option prints a label that lists the available images stored in the
printer’s RAM, Flash memory, or optional memory card.
To print a list of the available images:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to select
PRINT
.
3. Press
SELECT to deselect the parameter.
Table 12 • Printer Parameters (Page 10 of 26)
Parameter
Action/Explanation
Configuration
Control Panel Parameters
80
79695L-002 Rev. A ZM™ Series/RZ™ Series User Guide 5/12/08
List Formats
This option prints a label that lists the available formats stored in the
printer’s RAM, Flash memory, or optional memory card.
To print a list of the available formats:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to select
PRINT
.
3. Press
SELECT to deselect the parameter.
ZPL, XML, EPL, APL-D
APL-I only
List Setup
This option prints a configuration label (see Figure 11 on page 67), which
lists the current printer configuration.
To print a configuration label:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to select
PRINT
.
3. Press
SELECT to deselect the parameter.
APL-I only Print Software Configuration Label
A software configuration label lists pages, formats, and bar codes that are
defined for the printer. Other printer settings also are included.
To print this label:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to select
PRINT
.
3. Press
SELECT to deselect the parameter.
APL-I only Print Hardware Configuration Label
A hardware configuration label lists the memory options, printer metrics,
and printhead information.
To print this label:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to select
PRINT
.
3. Press
SELECT to deselect the parameter.
Table 12 • Printer Parameters (Page 11 of 26)
Parameter
Action/Explanation