User's Manual

71
Configuration
Control Panel Parameters
5/12/08 ZM™ Series/RZ™ Series User Guide 79695L-002 Rev. A
Adjust Print Speed
Adjusts the speed for printing a label (given in inches per second). Slower
print speeds typically yield better print quality. Print speed changes take
effect upon exiting Setup mode.
Default Value (ZPL, XML, APL-I, EPL): 2 IPS
Default Value (APL-D): 6 IPS
Range:
• 200 dpi: 2 to 10 IPS
• 300 dpi: 2 to 8 IPS
• 600 dpi: 1 to 4 IPS
To change the value shown:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to increase the value.
3. Press
MINUS (-) to decrease the value.
4. Press
SELECT to accept any changes and deselect the parameter.
Table 12 • Printer Parameters (Page 2 of 26)
Parameter
Action/Explanation
Configuration
Control Panel Parameters
72
79695L-002 Rev. A ZM™ Series/RZ™ Series User Guide 5/12/08
Adjust the Tear-Off Position
This parameter establishes the position of the media over the
tear-off/peel-off bar after printing.
See Figure 13. Higher numbers move the media out (the tear line moves
closer to the leading edge of the next label), and lower numbers move the
media in (the tear line moves closer to the edge of the label just printed).
Figure 13 • Tear-Off Position Adjustment
Default Value (ZPL, EPL, APL-I): 0
Range (ZPL, EPL, APL-I): -120 to +120
Default Value (APL-D): +128i
Range (APL-D): +00i to +999i (inches), 0m to 2537m (metric)
To change the value shown:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to increase the value. Each press adjusts the tear-off
position by four dot rows.
3. Press
MINUS (-) to decrease the value. Each press adjusts the tear-off
position by four dot rows.
4. Press
SELECT to accept any changes and deselect the parameter.
Table 12 • Printer Parameters (Page 3 of 26)
Parameter
Action/Explanation
1
Media direction
2
Factory-set tear line location at position 00
1
2