User's Manual

Operations
Load Media
51
79695L-002 Rev. A ZM™ Series/RZ™ Series User Guide 5/12/08
4. Close the printhead assembly.
5. If the printer is paused (the Pause light is on), press PAUSE to enable printing. Cutting
begins automatically.
Additional Steps for Rewind Mode
After completing Beginning Steps for all Print Modes and Printer Options on page 41,
continue with this section to operate the printer in Rewind mode. For additional procedures
related to the rewind option, see Routine Maintenance for the Rewind Option on page 106.
To operate the printer in Rewind mode, complete these steps:
1. Pull approximately 18 in. (500 mm) of media through the front of the printer.
52
Operations
Load Media
5/12/08 ZM™ Series/RZ™ Series User Guide 79695L-002 Rev. A
2. Feed the media over the peel assembly (1).
3. Feed the media under the media alignment roller (1).
4. Loosen the thumbscrew on the rewind media guide.
5. Slide the rewind media guide all the way out, and then fold it down.
1
1