User's Manual

Operations

Load Media

79695L-002 Rev. A ZM™ Series/RZ™ Series User Guide 5/12/08

Additional Steps for Peel-Off Mode (with or without Liner Take-Up)

After completing Beginning Steps for all Print Modes and Printer Options on page 41,

continue with this section to operate the printer in Peel-Off mode with or without liner take-up.

Your printer must have the Peel option, the Liner Take-Up option, or the Rewind option

installed. See Print Modes and Printer Options on page 38 for more information.

For additional procedures related to the rewind option, see Routine Maintenance for the

Rewind Option on page 106.

To operate the printer in Peel-Off mode, complete these steps:

1. Extend the media approximately 18 in. (500 mm) out of the printer.

2. Remove the exposed labels so that only the liner remains.

Operations

Load Media

5/12/08 ZM™ Series/RZ™ Series User Guide 79695L-002 Rev. A

3. Push down the peel-off mechanism release lever to open the peel assembly.

4. Feed the liner over the tear-off/peel-off bar (1) and behind the peel assembly (2). Make

sure that the end of the liner falls outside of the printer.

5. Complete this step only if you want to use Peel-Off mode with liner take-up. Your printer

must have the Liner Take-Up option or the Rewind option installed. Follow the

instructions for your printer option.

Rewind Option Liner Take-Up Option

a. Feed the liner under the media

alignment roller (

1).

a. Slide the liner into the slot in the

liner take-up spindle (

1).