User's Guide

___________________________________________________________________________
User Guide
___________________________________________________________________________ 28
TFF-2220-00AA and TFF-2221-00AA User’s Guide D1436 Rev B
©2008 Zebra Enterprise Solutions. WhereCall IV and all product names and numbers are Zebra Enterprise Solutions trademarks. All other trademarks are the property of their respective owners.
5 WHERECALL IV LCD DISPLAY MESSAGES
Display
Messa
g
e
Display Meaning Comments Action required
“CALL ”
(
flashin
g)
CALL mode button blinks are
being transmitted.
This mode will continue for 60
seconds following a button press.
None
CustCall
(
flashin
g
)
“CALL ”
10h 42m
(alternating)
This display follows the Call”
display and indicates the
elapsed time from the last
button press.
The time advances from
1m until it reaches
9d23h59m then holds until the
button is pressed again.
None
CustCall
10h 42m
(alternating)
--“ON --
(
flashin
g)
SWITCH mode where the tag
will transmit Switch ID 0 with
tag status 2.
In SWITCH mode, each button
press will toggle between
-- ON -- and - OFF --.
None
Cust ON1
(
flashin
g)
Cust ON1
Cust ON2
(
alternatin
g
)
- “OFF --
(
flashin
g
)
SWITCH mode where the tag
will transmit Switch ID 0 with
tag status 4.
In SWITCH mode, each button
press will toggle between
-- ON -- and - OFF --.
None
CustOFF1
(
flashin
g
)
CustOFF1
CustOFF2
(
alternatin
g
)
********
Indicates that the user has held
the button for several seconds
and the unit will turn off when
released
After the button is release, the
unit will display its firmware
versions before turning off.
Release the button
to turn the
WhereCall IV off.
PWR OFF
Indicates that the WhereCall
IV is in PWR OFF mode
Pressing the button will turn the
unit on again into the mode
(CALL or SWITCH) that the
unit was in prior to being turned
off.
None