User's Guide

___________________________________________________________________________
User Guide
___________________________________________________________________________ 18
TFF-2220-00AA and TFF-2221-00AA User’s Guide D1436 Rev B
©2008 Zebra Enterprise Solutions. WhereCall IV and all product names and numbers are Zebra Enterprise Solutions trademarks. All other trademarks are the property of their respective owners.
3.8 Installing WhereCall IV with Screw Mounting Bracket
1. Using a 5/64 inch hex drive bit, remove 4 screws from the bottom cover as shown in
Figure 7.
2. Align the mounting bracket so the 4 screw holes align with the 4 screw holes in the
WhereCall IV bottom cover. Be sure the four counter sunk holes in the mounting bracket
are visible and not against the WhereCall IV bottom cover. Reinsert the screws through the
bracket and into the bottom cover of WhereCall IV, with torque set to 6.0 + .6 inch-
pounds [0.68 + 0.07 Newton-meters]. See figure 10.
3. Attach mounting bracket in the desired location using two screws or rivets through the
counter sunk holes at the ends of the mounting bracket. The 0.188 inch [4.78 mm]
diameter holes are spaced 7.0 inches apart.
Figure 10: Screw Mounting Bracket Installed
7.0 inch [177.8 mm]