User's Guide

___________________________________________________________________________
User Guide
___________________________________________________________________________ 16
TFF-2220-00AA and TFF-2221-00AA User’s Guide D1436 Rev B
©2008 Zebra Enterprise Solutions. WhereCall IV and all product names and numbers are Zebra Enterprise Solutions trademarks. All other trademarks are the property of their respective owners.
Figure 7: Attaching WhereCall IV to Mounting Bracket
3.6 Installing WhereCall IV with Cable Hanging Bracket
1. Using a 5/64 inch hex drive bit, remove 4 screws from the bottom cover as shown in
Figure 7.
2. Align the mounting bracket so the 4 screw holes align with the 4 screw holes in the
WhereCall IV bottom cover. Be sure the four counter sunk holes in the mounting
bracket are visible and not against the WhereCall IV bottom cover. Reinsert the screws
through the bracket and into the bottom cover of WhereCall IV, with torque set to
6.0 +
.6 inch-pounds [0.68 + 0.07 Newton-meters]. See figure 8.
3. Hang the mounting bracket in the desired location by threading the cable into the slot on
the end of the bracket.
Remove and save these
4 screws