User's Manual

___________________________________________________________________________
User Guide
___________________________________________________________________________ 20
WhereCall III User Guide D1157 rev A
© Copyright WhereNet, Corp. 2006
WhereNet Confidential
Display
Message Display Meaning
Keep
Alive
Blinks Comments Action required
“CALL”
(blinking)
Button blinks are being
transmitted.
Yes This mode will continue for
60 seconds following a
button press.
None
“HH:MM”
Colon
flashing
Indicates the elapsed time
from the last button press.
Yes The time advances until it
reaches 23:59 then holds
until the button is pressed.
None
“CALL”
displayed for
more than
60 seconds.
If the button is pressed while
the display indicates CALL,
the display will reset for
another 60 seconds.
Yes The WhereCall will send a
“Button Blink” for each
button press.
None
“-OFF”
switch mode
(blinking)
Switch mode where the tag
will transmit Switch ID 0.
Yes From Call mode, the button
must be held for several
seconds after the “8888”
code is displayed and until
the code “S?” is shown.
None
“-ON”
switch mode
(blinking)
Switch mode where the tag
will transmit Switch ID 1.
Yes Once in switch mode, each
button press will toggle
from “-OFF” to “-ON” and
vice versa.
None
“b ?” mode
change from
switch mode
back to call
mode
(not
blinking)
Indicates that the user can
now change modes if
desired.. To change modes
you must release then press
the button again within 5
seconds. Releasing the
button without pressing it
again will cause firmware
date code to display and the
WhereCall III to enter the
“OFF” mode.
Yes The button must be held for
several seconds during
which the “8888” code will
be momentarily displayed.
Pressing the button again
will generate a “CALL”
response.
Press the button to initiate
“CALL” operation.