User's Manual
Table Of Contents
___________________________________________________________________________
User Guide
___________________________________________________________________________ 16
WhereCall III User Guide D1157 rev A
© Copyright WhereNet, Corp. 2006
WhereNet Confidential
4. Drill screw pilot holes as needed into the mounting surface.
5. Remove front cover screws as shown in Figure 5.
6. Inserts #6 screws through holes in the front panel of the WhereCall III and
gently tighten to a snug fit (12 to 15 in-oz). Do not distort case by over-
tightening.
____________
Do not over-tighten screws. Damage to the WhereCall III might result if screws
are over-tightened.
CAUTION
____________
3.6 Hanging Cable Bracket
The WhereCall III may be installed from an overhead cable for ease of use in a
workstation where mounting on flat surfaces is unsafe or inconvenient. Hanging cable
brackets are not included with the WhereCall III but are available from WhereNet.
Contact your WhereNet Account Manager for parts information.
Figure 6: Hanging cable bracket