User's Manual
Table Of Contents
___________________________________________________________________________
User Guide
___________________________________________________________________________ 13
WhereCall III User Guide D1157 rev A
© Copyright WhereNet, Corp. 2006
WhereNet Confidential
2. Clean the mounting surface and the back plate of the WhereCall III with
isopropyl alcohol.
3. Select two foam tape squares, remove the adhesive backing from one side
only and apply them to the back plate of the WhereCall III as shown in
Figure 2.
4. Remove the adhesive backing from the exposed surface of the tape squares.
5. While holding the WhereCall III, aligned to the desired position. Gently press
the unit onto the mounting surface.