User's Manual

Data Capture 3 - 7
4. Move the TC8000 until the bar code is visible on the screen.
5. The Decode LED lights green, a beep sounds and the device vibrates, by default, to indicate the bar code was
decoded successfully.
6. The captured data appears in the text field.
7. Release the trigger.
Bar Code Capture with RS507 Hands-Free Imager
Pair the RS507 with the TC8000. See Pairing the RS507 Hands-Free Imager Using SSI on page 3-8 or Pairing the
RS507 Hands-Free Imager Using Bluetooth HID on page 3-9 for more information.
1. Ensure that an application is open on the device and a text field is in focus (text cursor in text field).
2. Point the RS507 at a bar code.
Figure 3-8 Bar Code Scanning with RS507
3. Press and hold the trigger.
The red laser aiming pattern turns on to assist in aiming. Ensure the bar code is within the area formed by the
cross-hairs in the aiming pattern. The aiming dot is used for increased visibility in bright lighting conditions.
The RS507 LEDs light green, a beep sounds to indicate the bar code was decoded successfully. Note that
when the RS507 is in Pick List Mode, the RS507 does not decode the bar code until the center of the crosshair
touches the bar code.
Review Copy