User's Manual
Table Of Contents
- Revision History
- Table of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Using the TC8000
- Chapter 3 Data Capture
- Introduction
- Status LED
- Laser Scanning
- Imaging
- Digital Camera
- Scanning Considerations
- Bar Code Capture with Laser Scanner
- Bar Code Capture with Imager
- Bar Code Capture with Camera
- Bar Code Capture with RS507 Hands-Free Imager
- Pairing the RS507 Hands-Free Imager Using SSI
- Pairing the RS507 Hands-Free Imager Using Bluetooth HID
- Hands Free Scanning
- Ergonomic Recommendations During Scanning
- DataWedge
- Pairing the RS507 Hands-Free Imager using HID
- Pairing the RS507 Hands-Fee Imager Using SSI
- Chapter 4 Wireless
- Chapter 5 Applications
- Chapter 6 Accessories
- Accessories
- 2-Slot Charge Only Cradle
- 5-Slot Charge Only Cradle
- 5-Slot Charge Only Cradle with Battery Charger
- 5-Slot Ethernet Cradle
- 5-Slot Ethernet Cradle with Battery Charger
- 4-Slot Battery Charger
- USB and Charging Cable
- Quick Disconnect Audio Adapter
- 3.5 mm Audio Adapter
- Desktop Stand
- Cart Mount
- Quick-Draw Soft Holster
- Presentation Holster
- Stylus
- Chapter 7 Maintenance and Troubleshooting
- Appendix A Specifications
- Index
Getting Started 1 - 11
Figure 1-13 Battery Screen
The Battery screen lists the applications using the battery. The discharge graph at the top of the screen shows the
rate of the battery discharge since last charged (short periods of time when connected to a charger are shown as
thin green lines at the bottom of the chart), and how long it has been running on battery power.
Touch an application in the Battery screen to display details about its power consumption. Different applications
display different information. Some applications include buttons that open screens with settings to adjust power
use.
Low Battery Notification
When the battery charge level drops below 15%, the TC8000 displays a notice to connect the TC8000 to power.
Place the TC8000 into a cradle to charge the battery.
Figure 1-14 Low Battery Notification
When the battery charge drops below 10%, the TC8000 displays a notice to connect the TC8000 to power. The
user must charge the battery using one of the charging accessories.
When the battery charge drops below 5%, the TC8000 turns off.
TC8000Place the TC8000 into a cradle to charge the battery.
Battery Optimization
Observe the following battery saving tips:
•
Set the screen to turn off after a short period of non-use. See Setting Screen Timeout Setting on page 1-13.
Review Copy