User's Manual
Table Of Contents
- Revision History
- Table of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Using the TC8000
- Chapter 3 Data Capture
- Introduction
- Status LED
- Laser Scanning
- Imaging
- Digital Camera
- Scanning Considerations
- Bar Code Capture with Laser Scanner
- Bar Code Capture with Imager
- Bar Code Capture with Camera
- Bar Code Capture with RS507 Hands-Free Imager
- Pairing the RS507 Hands-Free Imager Using SSI
- Pairing the RS507 Hands-Free Imager Using Bluetooth HID
- Hands Free Scanning
- Ergonomic Recommendations During Scanning
- DataWedge
- Pairing the RS507 Hands-Free Imager using HID
- Pairing the RS507 Hands-Fee Imager Using SSI
- Chapter 4 Wireless
- Chapter 5 Applications
- Chapter 6 Accessories
- Accessories
- 2-Slot Charge Only Cradle
- 5-Slot Charge Only Cradle
- 5-Slot Charge Only Cradle with Battery Charger
- 5-Slot Ethernet Cradle
- 5-Slot Ethernet Cradle with Battery Charger
- 4-Slot Battery Charger
- USB and Charging Cable
- Quick Disconnect Audio Adapter
- 3.5 mm Audio Adapter
- Desktop Stand
- Cart Mount
- Quick-Draw Soft Holster
- Presentation Holster
- Stylus
- Chapter 7 Maintenance and Troubleshooting
- Appendix A Specifications
- Index
CHAPTER 1 GETTING STARTED
Introduction
This chapter describes the features of the TC8000 and explains how to install and charge the battery and how to
reset the TC8000.
Unpacking
Carefully remove all protective material from the TC8000 and save the shipping container for later storage and
shipping.
Verify that box contains all the equipment listed below:
•
TC8000
•
Battery
•
Regulatory Guide.
Inspect the equipment for damage. If you are missing any equipment or if you find any damaged equipment,
contact Support immediately. See Service Information on page xiii for contact information.
Removing the Screen Protection Film
A screen protection film is applied to the TC8000 screen to protect the screen during shipping. To remove the
screen protector, carefully lift the thin film off the display.
Review Copy