User's Manual

7 - 6 TC8000 User Guide
A message appears
stating that the TC8000
memory is full.
Too many files stored
on the TC8000.
Delete unused memos and records. You can save these
records on the host computer.
Too many applications
installed on the
TC8000.
If you have installed additional applications on the TC8000,
remove them to recover memory. See
Uninstalling an
Application on page 10-4
.
The TC8000 does not
accept scan input.
Scanning application
is not loaded.
Verify that the TC8000 is loaded with a scanning application.
See the System Administrator.
Unreadable bar code. Ensure the symbol is not defaced.
Distance between
imager exit window
and bar code is
incorrect.
Move the TC8000 closer or further from the bar code to the
proper scanning range.
TC8000 is not
programmed for the
bar code.
Verify that the TC8000 can read the type of bar code being
scanned (See
Technical Specifications ). Ensure that the bar
code parameters are set properly for the bar code being
scanned.
TC8000 is not
programmed to
generate a beep.
Verify that a beep on a good decode is used. See
Bar Code
Input on page 9-10
for more information.
Battery is low. If the scanner is still not reading symbols, contact the
distributor or service.
During USB data
communications, no data
was transmitted, or
transmitted data was
incomplete.
Incorrect cable
connection.
See
Chapter 6, Accessories .
Communications
software is not
installed or configured
properly.
Perform setup as described in
Chapter 6, Accessories .
Ensure that a sync program is installed on the host computer.
Cannot sync with Host
Computer
Host computer not
configured properly.
Ensure that sync program on the host computer is set to allow
USB connections.
Table 7-1 Troubleshooting the TC8000 (Continued)
Problem Cause Solution
Review Copy