User's Manual
Table Of Contents
- Revision History
- Table of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Using the TC8000
- Chapter 3 Data Capture
- Introduction
- Status LED
- Laser Scanning
- Imaging
- Digital Camera
- Scanning Considerations
- Bar Code Capture with Laser Scanner
- Bar Code Capture with Imager
- Bar Code Capture with Camera
- Bar Code Capture with RS507 Hands-Free Imager
- Pairing the RS507 Hands-Free Imager Using SSI
- Pairing the RS507 Hands-Free Imager Using Bluetooth HID
- Hands Free Scanning
- Ergonomic Recommendations During Scanning
- DataWedge
- Pairing the RS507 Hands-Free Imager using HID
- Pairing the RS507 Hands-Fee Imager Using SSI
- Chapter 4 Wireless
- Chapter 5 Applications
- Chapter 6 Accessories
- Accessories
- 2-Slot Charge Only Cradle
- 5-Slot Charge Only Cradle
- 5-Slot Charge Only Cradle with Battery Charger
- 5-Slot Ethernet Cradle
- 5-Slot Ethernet Cradle with Battery Charger
- 4-Slot Battery Charger
- USB and Charging Cable
- Quick Disconnect Audio Adapter
- 3.5 mm Audio Adapter
- Desktop Stand
- Cart Mount
- Quick-Draw Soft Holster
- Presentation Holster
- Stylus
- Chapter 7 Maintenance and Troubleshooting
- Appendix A Specifications
- Index
Maintenance and Troubleshooting 7 - 3
•
Can of compressed air with a tube.
Cleaning the TC8000
Housing
Using the alcohol wipes, wipe the housing including the Scan key.
Display
The display can be wiped down with the alcohol wipes, but care should be taken not to allow any pooling of liquid
around the edges of the display. Immediately dried the display with a soft, non-abrasive cloth to prevent streaking.
Scan Exit Window
Wipe the scan exit window periodically with a lens tissue or other material suitable for cleaning optical material
such as eyeglasses.
Power Connector
1. Remove the main battery from TC8000.
2. Install the battery cover.
3. Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.
4. Repeat at least three times.
5. Use the cotton tipped applicator dipped in alcohol to remove any grease and dirt near the connector area.
6. Use a dry cotton tipped applicator and repeat steps 3 through 6.
7. Spray compressed air on the connector area by pointing the tube/nozzle about ½ inch away from the surface.
8. Inspect the area for any grease or dirt, repeat if required.
Cleaning Cradle Connectors
Use this procedure to clean the connectors on a cradle:
1. Remove power from the cradle.
2. Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.
3. Rub the cotton portion of the cotton tipped applicator along the pins of the connector. Slowly move the
applicator back-and-forth from one side of the connector to the other. Do not let any cotton residue on the
connector.
4. All sides of the connector should also be rubbed with the cotton tipped applicator.
5. Spray compressed air in the connector area by pointing the tube/nozzle about ½ inch away from the surface.
CAUTION
Do not point nozzle at yourself and others, ensure the nozzle or tube is away from your face.
CAUTION
Do not point nozzle at yourself and others, ensure the nozzle or tube is pointed away from your face.
Review Copy