User's Manual
Table Of Contents
- Revision History
- Contents
- List of Tables
- List of Figures
- About This Guide
- Getting Started
- Using the TC55
- Calls
- Applications
- Data Capture
- Wireless
- Wireless Wide Area Networks
- Wireless Local Area Networks
- Bluetooth
- Adaptive Frequency Hopping
- Security
- Bluetooth Profiles
- Bluetooth Power States
- Bluetooth Radio Power
- Discovering Bluetooth Device(s)
- Changing the Bluetooth Name
- Connecting to a Bluetooth Device
- Selecting Profiles on the Bluetooth Device
- Unpairing a Bluetooth Device
- Pairing with the CS3070
- Pairing the RS507 Hands-Fee Imager
- Near Field Communications
- Accessories
- Maintenance and Troubleshooting
- Technical Specifications
- Index
5
6
7
8
9
Enter
Pairing the RS507 Hands-Fee Imager
An RS507 Hands-free Imager can be used with the device to capture bar code data.
Procedure:
1 Ensure that Bluetooth is enabled on both devices.
2 Ensure that the Bluetooth device to discover is in discoverable mode.
3 Ensure that the two devices are within 10 meters (32.8 feet) of one another.
4 Place the RS507 in Human Interface Device (HID) mode. If the RS507 is already in HID mode, skip to step 5.
a Remove the battery from the RS507.
b Press and hold the Restore key.
c Install the battery onto the RS507.
d Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash green.
e Scan the bar code below to place the RS507 in HID mode.
Figure 98: RS507 Bluetooth HID Bar Code
5
Touch .
6
Touch .
7
Touch Bluetooth.
8 Touch SCAN FOR DEVICES. The device begins searching for discoverable Bluetooth devices in the area and
displays them under AVAILABLE DEVICES.
118 | Wireless
Send Feedback | February 2014 | MN000xxxA01
PRELIMINARY