User's Manual
Table Of Contents
- Revision History
- Table of Contents
- About This Guide
- Getting Started
- Operation
- Data Capture
- Accessories
- Maintenance & Troubleshooting
- Introduction
- Maintaining the SB1
- Battery Safety Guidelines
- Cleaning
- Specifications
- Glossary
- Index
Accessories 4 - 11
Armband
Use the Armband to wear the SB1 on the arm.
To install the armband:
Feed the end of the armband through the buckle ensuring that the rubber grip side is facing inside.
Hook Material
Rubber Grip Material
Buckle
Figure 4-15
Armband
1. Slide the armband onto the arm to a comfortable location.
2. Pull the end of the armband and fold over so that the hook material attaches to the loop material.
Loop Material
Hook Material
Figure 4-16
Install Armband
3. Insert the clip of the holster in between the two sections of the armband.
PRELIMINARY