User's Manual
Table Of Contents
- Revision History
- Table of Contents
- About This Guide
- Getting Started
- Operation
- Data Capture
- Accessories
- Maintenance & Troubleshooting
- Introduction
- Maintaining the SB1
- Battery Safety Guidelines
- Cleaning
- Specifications
- Glossary
- Index
Accessories 4 - 9
Holster
Use the holster to store the SB1 provides a holder for the SB1. The holster holds the SB1 on a belt or waist
band and provides a tether to attach the SB1 to the holster.
Figure 4-10
Holster
1. Feed the loop end of the tether through one of the holes in the holster.
2. Feed the loop end of the tether through the other hole.
3. Pull the loop up so that enough of the loop is above the hole so that the clip end fits through.
Figure 4-11
Install SB1 onto Holster
Feed the clip end of the tether through the loop end.
Continue to feed the tether through the loop and then pull taught.
Figure 4-12
Install SB1 onto Holster
PRELIMINARY