User's Manual

RFS4011 Series Integrated Services Controller: Installation Guide

4.3 Connecting USB Devices

The RFS4011 contains one USB port for connecting USB flash storage devices to the controller. The

controller can use the USB flash storage device for file transfers and firmware updates. Follow the

setup instructions below to connect the devices to the controller and access devices through the Web

UI or Command Line Interface.

1. Connect the USB flash drive to the USB .

2. Wait a few seconds for the drive to be recognized by the controller.

3. Follow the instructions in the RFS Series Integrated Services Controller Wi-NG System

Reference Guide or RFS Series Integrated Services Controller Wi-NG CLI Reference Guide for

more information on accessing USB storage devices from the controller for file transfers or

firmware updates.

NOTE The controller supports USB flash devices formatted with FAT or VFAT

(FAT32) filesystems only. If your flash storage device is formatted with

another filesystem, format your device with a FAT32 filesystem.

USB

port

RFS4000_Baseline.book Page 18 Tuesday, September 28, 2010 9:55 AM