Users Manual Part 3

Routine Maintenance
Cleaning Schedule and Procedures
110
P1106464-001 ZT411/ZT421 Color Touch User Guide 5/9/19
Clean and Lubricate the Cutter Module
If the cutter is not cutting the labels cleanly or if it jams with labels, clean the cutter blades.
After cleaning the blades, apply lubrication to them to help extend the life of your cutter
module.
To clean the cutter module, complete these steps:
1.
2.
Raise the media door.
3. Remove media that is loaded through the cutter module.
4. Loosen and remove the thumbscrew and lock washer on the cutter shield.
Caution • Turn off (O) the printer and disconnect it from the power source before
performing the following procedure.
Turn off (O) the printer and disconnect the AC power cord.
DRAFT