Users Manual Part 3

83
Printer Configuration and Adjustment
User Menus
5/9/19 ZT411/ZT421 Color Touch User Guide P1106464-001
Print > Applicator > Applicator Port Mode
Controls the way in which the applicator port’s “End Print” signal functions.
Print > Applicator > Start Print Mode
Determines if the applicator port’s “Start Print” signal is in level mode or pulse
mode.
Print > Applicator > Error on Pause
Determines how applicator port errors are treated by the printer. Enabling this
feature also causes the “Service Required” pin to be asserted.
Accepted values: Off
1 = End Print signal normally high, and low only
when the printer is moving the label forward.
2 = End Print signal normally low, and high only
when the printer is moving the label forward.
3 = End Print signal normally high, and low for
20 ms when a label has been printed and
positioned.
4 = End Print signal normally low, and high for
20 ms when a label has been printed and
positioned.
Related ZPL command(s): ^JJ
SGD command used:
device.applicator.end_print
Accepted values: • Pulse—Start Print signal must be deasserted
before it can be asserted for the next label.
• Level—Start Print signal does not need to be
deasserted to print the next label. As long as
the Start Print signal is low and a label is
formatted, a label prints.
Related ZPL command(s):
^JJ
SGD command used:
device.applicator.start_print
Accepted values: • ENABLED
• DISABLED
SGD command used:
device.applicator.error_on_pause
Printer web page: View and Modify Printer Settings > Advanced
Setup > Error on Pause
DRAFT