Users Manual Part 2

Printer Setup and Operation

Load the Media—Peel-Off Mode (with our without Liner Take-Up)

5/9/19 ZT411/ZT421 Color Touch User Guide P1106464-001

9. Does the media that you are using require ribbon for printing? If you are not sure, see

Ribbon on page 11.

10. Close the media door.

11. Set the printer to Peel-Off mode (for more information, see Print > Label Position >

Collection Method on page 78).

12. Press PAUSE to exit pause mode and enable printing.

The printer may perform a label calibration or feed a label, depending on your settings.

13. For best results, calibrate the printer. See Print > Sensors > Manual Calibration

on page 81.

Media loading in Peel-Off mode is complete.

If using… Then…

Direct Thermal media (no ribbon needed) Continue with step 10.

Thermal Transfer media (ribbon needed)

a. If you have not already done so,

load ribbon in the printer. See

Load the Ribbon on page 43.

b. Continue with step 10.

DRAFT