User Manual
Table Of Contents
- Table of Contents
- Proprietary Statement
- Declaration of Conformity
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Configuration
- RFID Guidelines
- Routine Care and Adjustments
- Troubleshooting
- Data Connections
- Specifications
- Index
66 R4Mplus User Guide
Configuration
Configuration and Calibration LCD Displays
IP RESOLUTION*
IP Resolution
Depending on the selection, allows either the user (permanent) or the
server (dynamic) to select the IP address. For more information, see
ZebraNet Networking: PrintServer II Installation and Users Guide.
Default: Dynamic
Selections: Dynamic, permanent
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to display other choices.
3. Press SELECT to accept any changes and deselect the parameter.
IP PROTOCOLS*
IP Protocols
If dynamic was chosen in the previous parameter, this selection
determines the method(s) by which the PrintServer II receives the IP
address from the server. For more information, see ZebraNet Networking:
PrintServer II Installation and Users Guide.
Default: All
Selections: All, gleaning only, RARP, BOOTP, DHCP, DHCP/BOOTP
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to display other choices.
3. Press SELECT to accept any changes and deselect the parameter.
IP ADDRESS*
IP Address
This parameter allows you to select the IP address if permanent was
chosen in IP RESOLUTION. (If dynamic was chosen, the user cannot
select the address.) For more information, see ZebraNet Networking:
PrintServer II Installation and Users Guide.
1. Press SELECT to select the parameter.
2. Press PLUS (+) to increase the value of the selected digit.
3. Press MINUS (–) to move to the next digit.
4. Press SELECT to accept any changes and deselect the parameter.
SUBNET MASK*
Subnet Mask
This parameter selects the part of the IP address that is considered to be
part of the local network. It can be reached without going through the
default gateway.
Default: Permanent (user must set)
Selections: Dynamic (user may set, but server can assign), permanent
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to display other choices.
3. Press SELECT to accept any changes and deselect the parameter.
Table 7 • Printer Parameters and Other LCD Displays (Sheet 18 of 20)
Parameter/LCD Display Action/Explanation