User Manual

Configuration
Configuration and Calibration LCD Displays
R4Mplus User Guide 63
BACKFEED
Backfeed Sequence
This parameter establishes when and how much label backfeed occurs
after a label is removed or cut in the peel-off or cutter modes. It has no
effect in rewind or tear-off modes. This parameter setting can be
superseded by the ~JS instruction when received as part of a label
format (see the ZPL II Programming Guide Volume I).
The difference between the value entered and 100% establishes how
much backfeed occurs before the next label is printed. For example, a
value of 40 means that 40% of the backfeed takes place after the label is
removed or cut. The remaining 60% takes place before the next label is
printed. A value of “before” means that all backfeed takes place before
the next label is printed.
Default: Default (90%)
Selections: Default, after, before, 10%, 20%, 30%, 40%, 50%, 60%,
70%, 80%, off
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to display other choices.
3. Press SELECT to accept any changes and deselect the parameter.
LABEL TOP
Adjusting Label Top Position
The label top position adjusts the print position vertically on the label.
Positive numbers adjust the label top position further down the label
(away from the printhead); negative numbers adjust the position up the
label (toward the printhead).
Default: +0
Range: –120 to +120 dot rows
1. Press SELECT to select the parameter.
2. Press PLUS (+) to increase the value. The displayed value represents
dots.
3. Press MINUS (–) to decrease the value.
4. Press SELECT to accept any changes and deselect the parameter.
Table 7 • Printer Parameters and Other LCD Displays (Sheet 15 of 20)
Parameter/LCD Display Action/Explanation