User Manual

Configuration
Configuration and Calibration LCD Displays
R4Mplus User Guide 59
PROTOCOL
Setting Protocol
Protocol is a type of error checking system. Depending on the selection,
an indicator may be sent from the printer to the host computer signifying
that data has been received. Select the protocol that is requested by the
host computer. Further details on protocol can be found in the ZPL II
Programming Guide Volume I.
Default: None
Selections: None, Zebra, ACK_NACK
Zebra is the same as ACK_NACK except that with Zebra the response
messages are sequenced. If Zebra is selected, the printer must use
DTR/DSR host handshake protocol.
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to display other choices.
3. Press SELECT to accept any changes and deselect the parameter.
NETWORK ID
Setting Network ID
Network ID is used to assign a unique number to a printer used in an
RS-422/RS-485 network. This gives the host computer the means to
address a specific printer. If the printer is used in a network, you must
select a network ID number. This does not affect TCP/IP or IPX
networks.
Default: 000
Range: 000 to 999
1. Press SELECT to select the parameter.
2. Press PLUS (+) to increase the value of the selected digit.
3. Press MINUS (–) to move to the next digit.
4. Press SELECT to accept any changes and deselect the parameter.
Table 7 • Printer Parameters and Other LCD Displays (Sheet 11 of 20)
Parameter/LCD Display Action/Explanation