User Manual

54 R4Mplus User Guide
Configuration
Configuration and Calibration LCD Displays
INIT FLASH MEM
Initialize Flash Memory
Caution • Perform this operation only when it is necessary to erase all
previously stored information from the FLASH memory. Press PLUS (+)
to bypass this function.
1. Press SELECT to select the parameter.
If your printer is set to require a password, you are prompted to enter
the password.
2. Enter the password, then press SELECT.
3. Press PLUS (+) to select YES.
The display asks
INITIALIZE FLASH? .
4. Press PLUS (+) to select
YES .
The front panel LCD asks
ARE YOU SURE? .
5. Press MINUS (–) to select
NO and cancel the request. The INITIALIZE
FLASH
prompt is displayed.
or
Press PLUS (+) to select
YES and begin initialization. Depending on
the amount of free FLASH memory, initialization may take up to one
minute to complete.
6. Press SETUP/EXIT followed by SELECT. If initialization is still in
process, the front panel display flashes back and forth between the
phrases
CHECKING E: MEMORY and PRINTER IDLE .
When initialization is complete, the printer automatically exits the
configuration mode and the front panel displays
PRINTER READY .
7. Press SELECT to continue with the next prompt.
Table 7 • Printer Parameters and Other LCD Displays (Sheet 6 of 20)
Parameter/LCD Display Action/Explanation