User Manual

Configuration
Configuration and Calibration LCD Displays
R4Mplus User Guide 53
LIST ALL
List All
This selection is used to print a label that lists the five previous selections,
as described.
1. Press SELECT to select the parameter.
2. Press PLUS (+) to print a label listing all of the available fonts, bar
codes, images, formats, and the current printer configuration.
3. Press SELECT to deselect the parameter.
FORMAT CARD
A B
Initialize Memory Card
Caution • Perform this operation only when it is necessary to erase all
previously stored information from the optional memory card. Press
PLUS (+) to bypass this function.
1. Press SELECT to select the parameter.
If your printer is set to require a password, you are prompted to enter
the password.
2. Enter the password, then press SELECT.
3. Press the PLUS (+) to select B memory (PCMCIA card) or press
MINUS (–) to select the A memory (internal compact flash).
The front panel LCD asks
ARE YOU SURE? .
4. Press MINUS (–) to select
No and cancel the request. The INITIALIZE
CARD
prompt is displayed.
or
Press PLUS (+) to select
YES and begin initialization.
FORMATTING CARD displays. Depending on the amount of memory
in the memory card, initialization may take up to three minutes to
complete. When formatting is complete,
FORMAT CARD displays.
5. Press SELECT to continue with the next prompt.
Table 7 • Printer Parameters and Other LCD Displays (Sheet 5 of 20)
Parameter/LCD Display Action/Explanation