User Manual

Troubleshooting
Printer Diagnostics
R4Mplus User Guide 97
Pause Self Test
This self test can be used to provide the test labels required when making adjustments to the
printer’s mechanical assemblies. See the sample printout in Figure 33.
Figure 33 • Pause Test Label
To perform the Pause Self Test, complete these steps:
1. Turn the printer Off (O).
2. Press and hold PAUSE while turning the printer On (l).
3. Release PAUSE after the DATA light turns off (approximately five seconds).
• The initial self test prints 15 labels at 2 in. (51 mm) per second, then automatically
pauses the printer. When PAUSE is pressed, an additional 15 labels print.
• Pressing CANCEL while the printer is paused alters the self test. When PAUSE is
pressed, the printer prints 15 labels at 6 in. (152 mm) per second.
• Pressing CANCEL again while the printer is paused alters the self test again. When
PAUSE is pressed, the printer prints 50 labels at 2 in. (51 mm) per second.
• Pressing CANCEL again while the printer is paused alters the self test a third time.
When PAUSE is pressed, the printer prints 50 labels at 6 in. (152 mm) per second.
• Pressing CANCEL again while the printer is paused alters the self test a fourth time.
When PAUSE is pressed, the printer prints 15 labels at the printer’s maximum speed.
• To exit this self test at any time, press and hold CANCEL.