User Manual
Table Of Contents
- Table of Contents
- Proprietary Statement
- Declaration of Conformity
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Configuration
- RFID Guidelines
- Routine Care and Adjustments
- Troubleshooting
- Data Connections
- Specifications
- Index
RFID Guidelines
ZPL II Commands for RFID
R4Mplus User Guide 77
Example • This example sets the printer to move the media to 800 dots from the top of the
media [or label length minus 800 from the bottom (leading edge) of the media] and voids the
rest of the media in case of an error. The printer will try to print two labels, then will pause the
printer if printing and encoding fail.
^XA
^RS,800,,2,P^FS
^XZ
Figure 28 shows the resulting voided label. Note where the void starts. The media has been
moved 800 dot rows from the top of the label (label length minus 800 dot rows from the
bottom (leading edge) of a label) to bring the transponder into the effective area to read/write a
tag. If the printer fails the operation, the rest of the media is voided.
Figure 28 • Sample Voided Label 1
Top of label
Start of RFID
operation
800 dot rows
Bottom of label
Label length minus
800 dot rows