User Manual
Table Of Contents
- Table of Contents
- Proprietary Statement
- Declaration of Conformity
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Configuration
- RFID Guidelines
- Routine Care and Adjustments
- Troubleshooting
- Data Connections
- Specifications
- Index
76 R4Mplus User Guide
RFID Guidelines
ZPL II Commands for RFID
e = error handling Send an error message to the host as an unsolicited message for each failure
and set the printer in error mode.
Note • To enable or disable the unsolicited error message, refer to the ^SX
and ^SQ commands. The parameter for the RFID error in these commands
is V.
Default value: N (no action)
Other values:
P = Place printer in Pause
E = Place printer in Error
Table 11 • ^RS Parameters (Continued)
Parameters Details
* Not applicable for R4Mplus.