User's Manual
Table Of Contents
- Contents
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Front Panel Controls
- RFID Guidelines
- Overview
- Getting Started with RFID
- Creating Basic RFID Label Formats
- RFID Label Format 1-Write a 96-bit Tag in Hexadecimal
- RFID Label Format 2-Write a 64-bit Tag in Hexadecimal
- RFID Label Format 3-Write a 96-bit Tag in ASCII
- RFID Label Format 4-Read Data from Tag and Print on Label
- RFID Label Format 5-Write Tag, Read Tag, and Print Data on Label
- RFID Label Format 6-Write Tag, Read Tag, and Return Results to Host
- ZPL II Commands for RFID
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Proprietary Statement
- Warranty Information
- Printer Software and Firmware License Agreement
- Index
Index
23063L-003 Rev. 2 12/17/04 R110Xi/R170Xi User Guide 167
printhead
cleaning, 117
early warning message, 47
head close setting, 54
head resistor value setting, 56
head test count setting, 56
pressure adjustment, 39
when to clean, 116
print modes
features, 142
selecting, 45
print network configuration label, 34
print quality
effect of printhead toggle pressure, 39
troubleshooting problems, 130
print server settings
default gateway, 61
IP address, 60
IP protocol, 60
subnet mask, 60
print speed setting, 44
print width setting, 46
product improvements, 151
proprietary statement, 151
protocol setting, 51
R
R110Xi
general specifications, 145
label specifications, 148
ribbon specifications, 147
R170Xi
general specifications, 146
label specifications, 148
ribbon specifications, 147
radiation exposure limits, 152
radio frequency information, 151
read power
change through front panel, 63
change using ZPL, 93
read RFID tag
read or write RFID format (^RF), 83
read RFID tag (^RT), 91
related documents, xii
relative humidity requirements, 10
remove used ribbon, 31
replace fuse, 122
report shipping damage, 9
reset network option, 61
reship the printer, 9
resynch mode setting, 58
return data to host computer (^HV), 80
RFID
calibrate RFID tag from front panel, 63
calibrate RFID tag using ZPL (^HR), 78
change read power through front panel, 63
change read power using ZPL, 93
change write power through front panel, 63
change write power using ZPL, 93
create label formats, 69
display tag data, 64
enable motion, 85
error status, 63
guidelines, 65
LCD displays, 62
number of retries for block (^RR), 86
power settings, 68
RFID setup command (^RS), 87
RFID tag type, 63
RFID test, 62
“smart” labels, 15
transponder placement, 66
verify write operation (^WV), 97
when to perform calibration, 68
ZPL commands, 77
ribbon
adhesive test, 17
create ribbon leader, 27
determining coated side, 16
load, 26
removal, 31
RIBBON IN
message, 128
ribbon LED setting, 58
ribbon low warning, 47
Ribbon Out
message, 127
scratch test, 17
specifications, 147
troubleshooting wrinkles, 131
when to use, 16
Ribbon S. setting, 58
ribbon sensor
calibration procedure, 50
cleaning, 119
location, 119
sensitivity calibration, 36
when to clean, 116
roll media loading, 21
routine maintenance, 115
RS-232 interface connections, 104
RS-422/RS-485 interconnections, 106