User's Manual

Configuration
Configuration and Calibration LCD Displays
R110/R170XiIIIPlus User Guide 73
START PRINT SIG Start Print Signal
This parameter determines how the printer reacts to the Start Print Signal input on pin
3 of the applicator interface connector at the rear of the printer.
• In Pulse Mode, labels print when the signal transitions from HIGH to LOW.
• In Level Mode, labels print as long as the signal is asserted LOW.
Caution • Start Print Signal is set by the applicator manufacturer and should not be
changed unless the factory defaults have been reloaded. The printer must be returned
to its designated setting for it to work properly.
• Press the right or left oval to display other choices.
Default: Pulse Mode
Selections: Pulse Mode, Level Mode
RESYNCH MODE Resynch Mode
This parameter determines how the printer reacts if the label synchronization is lost
and the label top is not where expected.
• Feed Mode—If the label top is not where expected, the printer feeds a blank
label to find the label top position.
• Error Mode—If the label top is not where expected, the printer stops, enters
Pause Mode, displays the message Error Condition Feed Label, flashes the
ERROR light, and asserts the Service Required signal (pin 10 on the Applicator
Interface Connector).
To resynch the media to the top of the label in Error Mode, press PAUSE to exit
Pause Mode. The
ERROR light stops flashing, and the Service Required signal is
deactivated. The action of the printer is determined by the Head Close
configuration selection (see Head Close on page 69).
• Press the right or left oval to toggle between choices.
Default: Feed Mode
Selections: Feed Mode, Error Mode
Table 1• Front Panel LCD Messages (Page 17 of 19)
LCD Description