User's Manual

62 R110/R170XiIIIPlus User Guide
Configuration
Configuration and Calibration LCD Displays
INITIALIZE CARD
A B
Initialize Memory Card
Caution • Perform this operation only when it is necessary to erase all previously
stored information from the memory card.
1. When the LCD displays INITIALIZE CARD, press the left oval to select the A
memory (internal CompactFlash) or the right oval to select B memory (PCMCIA
card). (If you are prompted for a password, enter your password using the
instructions in Password-Protected Parameters on page 56.)
The front panel LCD asks ARE YOU SURE?.
2. Do you wish to continue?
• Press the left oval to select NO to cancel the request and return to INITIALIZE CARD
prompt.
• Press the right oval to select YES and begin initialization.
FORMATTING CARD displays.
When formatting is complete, INITIALIZE CARD displays.
Note • Depending on the amount of memory in the memory card, initialization may
take up to three minutes to complete.
INIT FLASH MEM Initialize Flash Memory
Caution • Perform this operation only when it is necessary to erase all previously
stored information from Flash memory.
1. When the LCD displays INITIALIZE CARD, press the right oval to select YES. (If you
are prompted for a password, enter your password using the instructions in
Password-Protected Parameters on page 56.)
The LCD asks INITIALIZE FLASH.
2. Press the right oval YES.
The LCD asks ARE YOU SURE?.
3. Do you wish to continue?
• Press the left oval to select NO to cancel the request and return to the INIT FLASH
MEM prompt.
• Press the right oval to select YES and begin initialization.
When formatting is complete, INIT FLASH MEM displays.
Table 1• Front Panel LCD Messages (Page 6 of 19)
LCD Description