User's Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
54 R110/R170XiIIIPlus User Guide
Configuration
Overview
Overview
After you have installed the labels and ribbon and printed a configuration label, you can
change the printer’s settings using the front panel controls. For an overview of the front panel,
including descriptions of the buttons and lights, see Front Panel on page 3. If you need to
restore the printer to its factory default settings, see FEED and PAUSE Self Test on page 135.
Many printer settings may be controlled by your printer’s driver or label preparation software.
Please refer to the driver or software documentation for more information.
Enter Setup Mode
To enter Setup Mode, complete these steps:
1. Press SETUP/EXIT to enter Setup Mode.
2. Press either
NEXT/SAVE or PREVIOUS to scroll to the parameter that you wish to set.
Exit Setup Mode
To leave Setup Mode, complete these steps:
1. Press SETUP/EXIT.
The LCD displays SAVE CHANGES.
2. Press the left or right oval to display the save choices. The choices are described in the
following table.
.
Note • Printers that are operating on an IP network can be quickly configured with the
ZebraLink™ WebView (ZebraNet
®
PrintServer II required). For information, see the
ZebraNet Networking: PrintServer II Installation and User Guide.
LCD Display Description
PERMANENT Permanently saves the changes. Values are stored in the printer
even when power is turned off.
TEMPORARY Saves the changes until you change them again or until power is
turned off.
CANCEL Cancels all changes from the time you pressed
SETUP/EXIT
except the darkness and tear-off settings (if they were changed).