User's Manual

Print Modes
Remove Backing from Rewind Spindle
R110/R170XiIIIPlus User Guide 51
Remove Backing from Rewind Spindle
Rewind Mode and Peel-Off Mode use the rewind spindle. The label backing must be removed
every time you change labels for the printer to work correctly.
To remove label backing from the rewind spindle, complete these steps:
1. Have the labels run out?
• Ye s — continue with the next step.
• No — unwind approximately 36 in. (915 mm) of backing from the rewind
spindle. Cut or tear it off at the spindle.
2. Pull out the spindle hook.
3. Slide the backing off of the rewind spindle and discard.
4. Replace the spindle hook.
Important • It is not necessary to turn off the power to remove backing from the rewind
spindle. If power is turned off, all label formats and images, as well as any temporarily saved
parameter settings stored in the printer’s internal memory, are lost. When power is turned back
on, these items must be reloaded.