User's Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
Printer Operation
Load the Printer
R110/R170XiIIIPlus User Guide 25
To load the ribbon, complete these steps:
1. Align the segments of the ribbon supply spindle as shown in the following illustration.
2. Place the roll of ribbon on the ribbon supply spindle, and push the core as far back as it can
go. The following illustration shows the printer components that are mentioned in this
procedure.
3. If the printhead is closed, open it using the printhead lever.
4. Thread the ribbon leader and attached ribbon under the ribbon guide roller, through the
print mechanism, and past the platen roller.
1
Top roller
2
Ribbon take-up spindle
3
Ribbon supply spindle
4
Ribbon guide roller
5
Ribbon leader attached to ribbon
6
Platen roller (not shown)
7
Printhead lever
(shown in the Open position)
Note • For the R170XiIIIPlus, thread the leader first through the ribbon dancer roller
assembly.
1 2
3
4
6
5
7