User's Manual

Index
R110/R170XiIIIPlus User Guide 155
printer settings (continued)
parallel communications, 64
parity, 65
passwords, 56
print darkness, 57
print method, 59
print speed, 57
print width, 59
protocol, 66
resynch mode, 73
ribbon length, 61
saving, 54
sensor type, 58
serial communications, 65
setting through front panel, 54
start print signal, 73
time, 75
verifier port, 72
ZPL mode, 68
printer setup
before you begin, 8
load the printer, 20
printhead
cleaning, 111
early warning message, 60
head close setting, 69
head resistor value setting, 71
head test count setting, 71
pressure adjustment, 37
when to clean, 110
print modes
Cutter Mode, 43
features, 138
Peel-Off Mode, 41
Rewind Mode, 45
Rewind Mode with Cutter option, 48
selecting, 40, , 58
Tear-Off Mode, 20
print quality
effect of printhead toggle pressure, 37
troubleshooting problems, 126
PrintServer II settings
default gateway, 77
IP address, 76
IP protocols, 76
IP resolution, 76
subnet mask, 77
print speed setting, 57
print width setting, 59
product improvements, v
proprietary statement, v
protocol setting, 66
R
R110XiIIIPlus
black mark specifications, 148
general specifications, 142
label specifications, 146
ribbon specifications, 144
R170XiIIIPlus
black mark specifications, 150
general specifications, 143
label specifications, 149
ribbon specifications, 145
related documents, xxiv
relative humidity requirements, 10
remove backing from rewind spindle, 51
remove used ribbon, 28
replace fuse, 117
report shipping damage, 9
reship the printer, 9
resynch mode setting, 73
Rewind Mode, 45
Rewind Mode with Cutter option, 48
rewind plate installation, 46
rewind spindle, 51
RFID
guidelines, 79
sample ZPL commands, 91
“smart” labels, 17
transponder placement, 80
ZPL commands, 81