User's Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
122 R110/R170XiIIIPlus User Guide
Troubleshooting
LCD Error Messages
HEAD ELEMENT
BAD
One or more of the printhead
elements failed the printhead
element test.
• If the failed elements affect your printing
application, replace the printhead.
• To override this error, disable the head test
count feature on the front panel by
defaulting the value to 0000.
Note • This message does not apply to 200 dpi and 300 dpi
R110XiIIIPlus printers. For 600 dpi R110XiIIIPlus printers, this message
would only be possible if the Head Test Count option is installed.
LCD Possible Cause Recommended Solution
If the Head Test Option is installed,
HEAD TEST COUNT will be listed
on the configuration label.