User Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
26 R110/R170XiIIIPlus User Guide
Printer Operation
Load the Printer
5. Pull the ribbon leader over the printhead and above the top roller as shown in the
following illustration.
6. Bring the ribbon leader and ribbon under the ribbon take-up spindle, and wrap them
around the spindle. The following illustration shows the ribbon leader wrapped around the
ribbon take-up spindle.
7. Turn the spindle counterclockwise until the ribbon stays on the spindle.
8. Close the printhead.
1
Ribbon leader
2
Printhead
1
Ribbon leader
2
Ribbon take-up spindle
1
2
1
2