User Manual

Printer Operation
Load the Printer
R110/R170XiIIIPlus User Guide 21
To load roll media, complete these steps:
1. Open the printhead.
2. Slide the media guide away from the printer frame. You might need to loosen the media
guide screw.
3. Put the roll of media on the media hanger.
4. Push the label core toward the printer frame. The labels must be aligned with the label
core.
5. Feed the media under the media guide roller and under the printhead.
6. Do you have the Cutter option?
• No — continue with the next step.
• Ye s — feed the media through the cutter.
7. Adjust the media supply guide so it is just touching, but does not restrict, the edge of the
media. The labels should lie flat as shown in the illustration.
8. Are you using direct thermal labels?
• Ye s — close the printhead and go to Print a Configuration Label on page 29.
• No — go to Load Ribbon on page 24.
Caution • The cutter blade is sharp. Do not rub or touch the blade with your fingers.
1
Printhead
2
Media guide roller
3
Labels/media
1
2
3