User Manual

Printer Setup
Connect the Printer to a Power Source
R110/R170XiIIIPlus User Guide 11
Connect the Printer to a Power Source
To connect the printer to a power source, complete these steps:
1. Turn the printer power switch (located on the rear of the printer) to the Off (O) position.
2. Plug the power cord into the mating connector on the rear of the printer.
3. Plug the other end of the power cord into the power source.
Power Cord
Depending on how your printer was ordered, a power cord may or may not be included. If one
is not included or if the one included is not suitable for your requirements, refer to the
following guidelines.
Your power cord must meed these standards:
• The overall length must be less than 9.8 ft (3.0 m).
• It must be rated for at least 5 A, 250 V.
• The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic
interference.
The ground connection is handled by the third wire (earth) in the power cord as
shown in the following illustration.
• The AC power plug and the IEC 320 connector must bear the certification mark of at least
one of the known international safety organizations shown in this illustration.
Caution • For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use an
IEC 320 female connector and the appropriate region-specific three-conductor grounded plug
configuration.
1
AC power plug for your country
2
3-conductor HAR cable
3
IEC 320 connector
4
Neutral earth live in contact view
1 2 3 4