User Manual

Index
R110/R170XiIIIPlus User Guide 153
front panel
buttons, 4
enter setup mode, 54
illustration, 3
LCD error messages, 121
LCD setup messages, 57
leave setup mode, 54
lights, 5
fuse replacement, 117
G
gray lines on labels, 127
H
HEAD COLD message, 124
HEAD ELEMENT BAD message, 122
HEAD OPEN message, 121
HEAD TOO HOT message, 123
host handshake setting, 66
I
IBM Twinax or Coax option, 13
idle display setting, 75
image not sharp, 126
images list, 61
initialize Flash memory, 62
initialize memory card, 62
inspect the printer, 9
interior cleaning, 111
international safety organizations, 11
IP settings
default gateway, 77
IP address, 76
IP resolution, 76
protocols, 76
subnet mask, 77
L
label-available sensor
location, 113
when to clean, 110
label backing removal, 51
label length maximum setting, 59
labels did not print, 129
label specifications by model, 146
labels per roll setting, 61
label top
printer cannot detect, 130
setting, 70
language selection, 75
LCD messages
adjust LCD settings, 74
error messages, 121
language selection, 75
setup mode, 57
leave setup mode, 54
liability, vi
light or no printing, 126
lights on front panel, 5
list settings
all settings, 61
bar codes, 61
fonts, 61
formats, 61
images, 61
setup, 61
load the printer
load fanfold media, 22
load roll media, 20
ribbon, 24
long calibration, 31
lower media sensor adjustment, 36
M
mark LED setting, 74
Mark Med S. setting, 74
maximum label length setting, 59
media
label specifications by model, 146
load fanfold media, 22
load roll media, 20
media LED setting, 74
media low warning, 60
RFID “smart” labels, 17
setting labels per roll, 61
setting media type, 58
types of media, 15