User Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
Specifications
Label Specifications
R110/R170XiIIIPlus User Guide 149
R170XiIIIPlus Printers
Label Specification Key
This table contains the key for the label modes, dimensions, and directions:
Important • Media registration and minimum label length are affected by label type and
width, ribbon type, print speed, and printer mode of operation. Performance improves as
these factors are optimized. Zebra recommends qualifying any application with thorough
testing.
T Tear-Off
PPeel-Off
C Cutter
RRewind
Minimum
Maximum
Preferred
Specifications R170Xi IIIPlus
Minimum label length 0.7 in. (18 mm) T
0.5in. (13mm) P
1.5in. (38mm) C
0.25 in. (6 mm) R
Total media width (label + backing, if any) 2.00 in. (51 mm)
7.1 in. (180 mm)
Total thickness (includes backing, if any) 0.003 in. (0.076 mm)
0.012 in. (0.305 mm)
Cutter maximum full-width media thickness 0.007 in. (0.18 mm)
Roll media core inside diameter 3 in. (76 mm)
Maximum roll diameter 8.0 in. (203 mm)
Inter-label gap 0.079 in. (2 mm)
0.118 in. (3 mm)