User Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
134 R110/R170XiIIIPlus User Guide
Troubleshooting
Printer Diagnostics
FEED Self Test
This test helps you choose the best darkness setting for your printer.
To perform a FEED self test, complete these steps:
1. Turn Off (O) the printer.
2. Press and hold
FEED while turning the power On (I). Hold FEED until the DATA light
turns off.
The printer prints a series of labels like the one below at various darkness settings
higher and lower than the darkness value shown on the configuration label.
3. Inspect the labels and determine which one has the best darkness setting for your
application. This value can be entered into the printer by setting the darkness during the
configuration procedure.
The value printed on that label is added to (plus) or subtracted from (minus) the
darkness value specified on the configuration label. The resulting numeric value
(0 to 30) is the best darkness value for that specific label/ribbon combination.